當濟南的夏天開啟 “燒烤模式”，戶外的遮陽蓬不再只是遮陽擋雨的工具，更成為對抗 40℃高溫的 “清涼結界”。這些看似普通的篷布之下，藏著材料選擇、結構設計與功能創新的多重巧思，讓居民和商戶在炎炎烈日下仍能享受一方涼爽天地。

　　When the summer in Jinan starts the "barbecue mode", outdoor sunshades are no longer just tools for shading and blocking rain, but also become a "cool barrier" to resist the high temperature of 40 ℃. Under these seemingly ordinary tarpaulins, there are multiple ingenious ideas in material selection, structural design, and functional innovation, allowing residents and merchants to enjoy a cool world under the scorching sun.

　　面料選擇：給陽光設道 “過濾屏障”

　　Fabric selection: Set up a "filtering barrier" for sunlight

　　遮陽蓬的核心是面料的 “防曬功力”。主流選擇是聚酯纖維（PET）混紡面料，密度達 300-600D，表面經特殊工藝涂覆防曬涂層（厚度 5-10μm），紫外線阻隔率可達 90%-95%（UPF 值 50+），相當于給陽光打了 “馬賽克”。深色面料（如墨綠、深灰）通過吸收部分光能轉化為熱能，并借助面料背面的鋁箔反射層（反射率≥80%），將熱量向外傳導，實測可使篷下溫度比露天低 3-5℃；淺色面料（米白、淺藍）則依靠高反射率（反射率≥70%）直接拒絕陽光直射，適合對降溫要求更高的商鋪門口。部分高端遮陽蓬采用 “空氣層編織法”，在面料中植入 0.5mm 的立體紗線，形成微米級空氣通道，加速熱空氣對流，降溫效果再提升 1-2℃。

　　The core of a sunshade is the "sun protection power" of the fabric. The mainstream choice is polyester fiber (PET) blended fabric with a density of 300-600D. The surface is coated with a special sun protection coating (thickness 5-10 μ m), and the UV blocking rate can reach 90% -95% (UPF value 50+), which is equivalent to "mosaic" of sunlight. Dark colored fabrics (such as dark green and dark gray) absorb some light energy and convert it into heat energy. With the help of the aluminum foil reflective layer on the back of the fabric (reflectivity ≥ 80%), the heat is transmitted outward. It has been measured that the temperature under the canopy can be reduced by 3-5 ℃ compared to outdoor conditions; Light colored fabrics (beige, light blue) rely on high reflectivity (reflectivity ≥ 70%) to directly reject direct sunlight, making them suitable for shops with higher cooling requirements. Some high-end sunshades use the "air layer weaving method" to implant 0.5mm three-dimensional yarn into the fabric, forming micrometer level air channels to accelerate hot air convection and further improve the cooling effect by 1-2 ℃.

　　結構設計：讓熱風 “有路可走”

　　Structural design: Let the hot air have a way to go

　　單純遮擋陽光不夠，還要讓篷下空氣 “活起來”。可調節角度支架是關鍵：通過液壓桿或齒輪組（調節精度 ±5°），遮陽蓬能根據太陽高度角動態調整（濟南夏日正午太陽高度約 75°，支架傾角常設為 60°-70°），避免陽光從底部 “漏” 入，同時形成 15-20° 的迎風面，引導自然風從篷底進入，經頂部排出，形成煙囪效應，風速可提升 0.5-1m/s。鏤空導流結構在篷布邊緣或支架連接處預留 5-10cm 的透氣縫，配合頂部的三角形凸起（高度 10-15cm），讓熱空氣上升時形成負壓，帶動下方冷空氣補充，實測篷內空氣置換頻率比封閉結構快 30%。針對西曬嚴重的陽臺遮陽蓬，常采用 “L 型延伸支架”，在主篷外側增設 30cm 寬的側擋板，阻擋側面斜射陽光，同時留出 10cm 通風口，避免形成悶熱死角。

　　Simply blocking sunlight is not enough, we need to make the air under the canopy come alive. The adjustable angle bracket is key: through a hydraulic rod or gear set (with an adjustment accuracy of ± 5 °), the sunshade can dynamically adjust according to the sun's altitude angle (the sun's altitude at noon on the summer solstice in Jinan is about 75 °, and the bracket's inclination angle is always between 60 ° and 70 °), avoiding sunlight from "leaking" from the bottom, while forming a 15-20 ° windward side, guiding natural wind from the bottom of the canopy to enter and be discharged through the top, forming a chimney effect, and the wind speed can be increased by 0.5-1m/s. The hollow diversion structure reserves a 5-10cm breathable seam at the edge of the tarpaulin or at the connection of the bracket, which is matched with a triangular protrusion at the top (height 10-15cm) to create negative pressure when hot air rises, driving the replenishment of cold air below. The measured air exchange frequency inside the canopy is 30% faster than that of the closed structure. For balcony sunshades with severe sun exposure, an "L-shaped extension bracket" is often used. A 30cm wide side panel is added on the outside of the main canopy to block oblique sunlight from the side, while leaving a 10cm ventilation opening to avoid creating stuffy blind spots.

　　隔熱技術：給篷體穿件 “降溫背心”

　　Thermal insulation technology: Wear a "cooling vest" on the canopy body

　　應對濟南夏季的持續高溫，遮陽蓬還有 “隱形降溫裝備”。反射隔熱涂層在篷布背面噴涂納米級二氧化鈦顆粒（粒徑≤50nm），對 600-1000nm 的近紅外光反射率達 85% 以上，減少面料吸熱，經測試在正午強光下，涂層面料溫度比普通面料低 8-10℃。雙層篷布結構則在內層使用低密度網眼布（孔徑 1-2mm），與外層防曬布形成 2-3cm 的空氣夾層，利用空氣導熱系數低的特性，構建靜態隔熱層，相當于給遮陽蓬加了 “中空玻璃”，篷下體感溫度可再降 2-3℃。部分定制遮陽蓬在支架鋼管內注入導熱油，通過循環管路將金屬支架吸收的熱量傳導篷頂散熱片，避免支架發燙影響周邊空氣。

　　To cope with the continuous high temperatures in Jinan during summer, sunshades also have "invisible cooling equipment". The reflective insulation coating is sprayed with nano-sized titanium dioxide particles (particle size ≤ 50nm) on the back of the tarpaulin, with a near-infrared light reflectivity of over 85% for 600-1000nm, reducing the heat absorption of the fabric. After testing, the temperature of the coated fabric is 8-10 ℃ lower than that of ordinary fabrics under strong noon light. The double-layer tarpaulin structure uses low-density mesh fabric (with a pore size of 1-2mm) in the inner layer, forming an air layer of 2-3cm with the outer sunscreen fabric. By utilizing the low thermal conductivity of air, a static insulation layer is constructed, which is equivalent to adding "hollow glass" to the sunshade, and the perceived temperature under the canopy can be further reduced by 2-3 ℃. Some customized sunshades are injected with thermal oil into the steel pipe of the bracket, and the heat absorbed by the metal bracket is conducted to the roof heat sink through the circulation pipeline, avoiding the bracket from overheating and affecting the surrounding air.

　　智能系統：讓遮陽蓬 “主動降溫”

　　Intelligent system: Let the sunshade "actively cool down"

　　科技的加入讓遮陽蓬從 “被動遮擋” 變為 “主動調節”。光感電動控制系統內置光敏傳感器（響應閾值 200-2000lux），當光照強度超過 500lux 時（相當于濟南上午 9 點后的光照），自動展開遮陽蓬；搭配溫度傳感器（精度 ±1℃），當篷下溫度超過 30℃時，同步啟動內置的微型風扇，通過篷頂預留的出風口形成內循環，加速降溫。手動調節裝置則考慮到用戶個性化需求：旋轉式搖把（齒輪傳動比 1:10）可在 30 秒內完成 0-90° 的角度調節，卡扣式伸縮桿（伸縮量 20-50cm）方便根據日照方位實時調整遮陽范圍，尤其適合窗臺、商鋪門口等需要靈活應對的場景。

　　The addition of technology has transformed sunshades from "passive occlusion" to "active adjustment". The light-sensitive electric control system is equipped with a built-in photosensitive sensor (with a response threshold of 200-2000lux). When the light intensity exceeds 500lux (equivalent to the light after 9am in Jinan), the sunshade will automatically unfold; Equipped with a temperature sensor (accuracy ± 1 ℃), when the temperature under the canopy exceeds 30 ℃, the built-in micro fan is synchronously activated to form an internal circulation through the reserved air outlet on the canopy, accelerating the cooling process. The manual adjustment device takes into account the personalized needs of users: the rotating handle (gear transmission ratio 1:10) can adjust the angle from 0-90 ° within 30 seconds, and the buckle type telescopic rod (extension of 20-50cm) is convenient for adjusting the shading range in real time according to the sunlight direction, especially suitable for flexible scenarios such as window sills and shop entrances.

　　本文由濟南遮陽蓬友情奉獻.更多有關的知識請點擊:http://www.hongroom.com真誠的態度.為您提供為的服務.更多有關的知識我們將會陸續向大家奉獻.敬請期待.

　　This article is a friendly contribution from Jinan retractable tent For more information, please click: http://www.hongroom.com Sincere attitude To provide you with comprehensive services We will gradually contribute more relevant knowledge to everyone Coming soon.